Americas
Strong fitIndustrial cooling & ventilation for Chile
Chile stretches through more climate zones than most continents, so the same product list cannot serve Calama and Puerto Montt. Ayzair supplies ductable evaporative coolers for the Atacama mining belt and the central valley, HVLS fans for packhouses, wineries and distribution sheds, and hammer exhaust fans for processing plants — all wound for 60 Hz at 220 V or 380 V.
Climate suitability — the honest version
Three climates in one country — the hyper-arid Atacama in the north, hot dry 32–35 °C summers in the central valley, cool and wet in the south
Northern Chile is close to the theoretical best case for evaporative cooling: Antofagasta, Calama and Iquique sit in the driest desert on earth, and mining camps, workshops and change houses there gain a large temperature drop for very little power. The honest constraint is not climate but water — availability and quality both. Central Chile around Santiago and Rancagua has hot dry summers that suit evaporative well. The south, from Concepción to Puerto Montt, is cool and damp, so there we sell ventilation and destratification instead.
San Antonio
Primary destination port
San Antonio 35–45 days
Sea transit from India
10–20days
Production lead time
4terms
EXW · FOB · CIF · CFR
The complete range
All six Ayzair families, supplied to Chile.
Every product we make is available in Chile — thirty-four models across six families. They are ordered here by how well each one suits the local climate and the industries that dominate this market, but nothing is off the list.
Industries
Who buys from us in Chile.
Logistics & compliance
Shipping to Chile.
| Destination ports | San Antonio · Valparaíso · Iquique |
| Sea transit | San Antonio 35–45 days from Nhava Sheva |
| Incoterms | EXW · FOB · CIF · CFR |
| Container loading | 20 ft: up to 28 coolers · 40 ft HQ: up to 60 coolers |
| Production lead time | 10–20 working days |
- Chilean mains runs at 60 Hz, 220 V single-phase and 380 V three-phase, against our 50 Hz production standard. We therefore wind Chilean orders for 60 Hz at the specified voltage as part of the build, because fitting a 50 Hz motor here would leave it spinning about a fifth too fast and drawing power beyond its rating.
- SEC approval applies to electrical equipment in Chile. We provide the technical file, test reports, wiring diagrams and CE, IEC, LVD and EMC certificates needed to support the SEC submission, and recommend starting it in parallel with manufacturing rather than on arrival.
- In the Atacama, water is the deciding factor — not heat. Desalinated or high-salinity supply scales pads and corrodes tanks quickly, so we ask for a water analysis and then specify pad media, bleed-off and cleaning intervals accordingly, or recommend HVLS fans where water simply is not available.
Chile enquiry
Get a proforma invoice for Chile.
Tell us the models and quantities, or just describe the building and let us size it. You will receive USD pricing, your Incoterm, a container loading plan and a confirmed lead time — within one working day.
Export desk
Answers
Supplying Chile — common questions
Cannot find what you need? Call +91 80871 10156 or WhatsApp us — an engineer, not a call centre, picks up.
Ask on WhatsAppHow well does evaporative cooling perform in the Atacama?
About as well as it can anywhere. Antofagasta, Calama and Iquique sit in the driest desert on earth, so the wet-bulb depression is very large and a ductable cooler drops supply air temperature dramatically for roughly 2 kW. The limit is water rather than climate, which is why we always confirm supply volume and water quality before recommending a system for a mine site.
Why does water quality matter so much?
Because evaporative cooling concentrates whatever the water contains. Northern Chilean sites often run on desalinated or high-salinity supply, and without an adequate bleed-off rate the dissolved solids scale the pads, choke airflow and corrode the tank within a season. We set pad grade, bleed rate and a cleaning schedule from an actual water analysis, and we will say so if the water makes evaporative the wrong choice.
What do you recommend for the south of Chile?
Different products entirely. From Concepción to Puerto Montt the climate is cool and wet, so cooling is not the problem — salmon plants, sawmills and cold stores need moisture and heat extraction plus destratification under high roofs. We specify hammer exhaust fans and HVLS fans for those sites, and we do not quote evaporative coolers where the air is already saturated.
City by city
Where we supply in Chile.
Each city page carries the local industrial areas, the arrival port, the climate reality and the full Ayzair range for that market.
Nearby markets
Also in Americas
Next step
Shipping to Chile?
Send your requirement and we will confirm the freight route, transit time, landed cost and whether our products genuinely suit your climate — before you commit.